Tractor Talk Discussion Board |
Re: Snap-On Impact driver
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris(WA) on October 16, 2004 at 20:42:47 from (204.182.70.237):
In Reply to: Snap-On Impact driver posted by JD Jim A. on October 16, 2004 at 19:19:00:
The drive end should be able to turn so you can reverse it. It will turn quite hard and snap over center. The idea is that as you hit it the mechanism inside turns the energy of the blow into rotational motion. It can be reversed to cause the energy to loosen or tighten. Have seen the idea of it going left or right throw a few people the first time they used one so I thought I would mention it. Nice tool to have. Esp. good to loosen the screws in the sides of motorcycle cases.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|