Tractor Talk Discussion Board |
Re: 2WD to MFWD conversion?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on October 25, 2004 at 08:39:13 from (142.177.83.104):
In Reply to: 2WD to MFWD conversion? posted by Jim in NH on October 24, 2004 at 19:04:56:
Hi Jim, I don't think it is rediculous. The cost could be though! I don't know much about the IH's, more about Ford, but I would look at the tranny or rear center section of the tractor first. Either one or the other has to support the transfer case. To this end, there must be an arpeture there for the case to mount up. I think Ford actually used different mid sections for 2 and 4 wheel drive tractors. You guessed it. The 2 wheel drives version didn't have the arpeture, or any place to bolt up the transfer case. The other thing to look hard at is the axle mounting points. It may simply be a matter of changing the pivots if they bolt up on both the front and rear. If the rear pivot is cast into the front bolster like the Ford 2 wheel drives, then you would also have to get the FWD front bolster. The last thing would be the drive gear on the tranny output shaft. Your's probably doesn't have that either. So, you have to see what's involved there. If you are determined to go ahead with it, find the guy with the burnt out cab tractors. Buying those parts new from a dealer will cost a pile. $2000 for a bare axle housing comes to mind....no gears, no swivel casings. THat would be about 1/3 of the front parts. Then add a drive shaft, bolster, transfer case. You get the picture. A new tractor would be cheaper. I don't want to discourage you. I love seeing these conversions, but practically speaking, it would be cheaper and easier to widen your search for another tractor. Take care. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|