Tractor Talk Discussion Board |
Re: Waldon 5000 loader
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TooManyToys on October 30, 2004 at 06:17:32 from (216.68.44.178):
In Reply to: Waldon 5000 loader posted by andy b. on July 09, 2004 at 09:03:41:
For info, try Mobile Products, Fairview, OK . Phone 405-227-3711 . I own a 5100 forklift unit, so if your 5000 is anything like the 5100 it will be a hydrostatic transmission. This is not like the automatic in your car. The engine powers a hydraulic pump at around 2000 psi. The pump powers the cylinders on the unit and the transmission. My unit is also poor vis vis hill climbing in 2nd gear and only fair in low. Mobile indicates it should climb around a 30 to 35 degree slope in low. Output from the transmission is mechanical driveshaft connection to front and rear Dana 60 full floater axles, not separate hydraulic motors on each axle. I believe you have to go to the 6100 series to get separate hydraulic motors. Transmission on the 5100 contains a single hydraulic motor to keep costs down. I am suspecting that my hydraulic motor needs repair based on the marginal hillclimbing but decent hydraulic system pressure under full stall. Other possible causes in your case might be dragging brakes. One caution with the hydrostats is that your brakes must, repeat must be in good working order with good safety handbrakes. Max wheel torque occurs with minimal pedal, so an attempt to stop a runaway will result in huge driveline stresses and may just simply snap a shaft or gear without stopping the unit. Hope this is helpful. Do you know a good source of used 15 inch wide tires and rim combinations for the unit? I have narrow semi-solid tires and the unit bogs down in soft stuff.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|