Tractor Talk Discussion Board |
Re: O.T. Homelite XL12 question-jdemaris??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jdemaris on November 10, 2004 at 05:40:16 from (209.23.31.41):
In Reply to: O.T. Homelite XL12 question-jdemaris?? posted by Kevin (FL) on November 09, 2004 at 17:41:51:
It has the same basic carburetor as many other saws, including German ones like Stihl. Tillotson or Walbro, both work the same. If it's flooding, the needle valve is probably leaking. Although the carb uses a vacuum activated diaphram to open and close the fuel needle valve, the valve is the same design as in a float carburetor on a tractor. So, if it gets any dirt in it, or gets worn, it will leak. Directly opposite the needle valve and seat, on the other side of the carburetor, is where the fuel enters and there is supposed to be small screen there. If it's missing, it will allow the needle to foul often. The diaphram on that side of the carb has little flapper valves in it, that serve as a low pressure fuel pump - to draw fuel out of the tank. If you buy a carb. kit it will come with a new screen. You probably already know, but a 2 cycle chain saw engine needs to have a good cylinder bore throughout, not just good compression on top of the piston. If it does not, the crankase won't charge properly in order to get fuel/air mixture into the combustion chamber. So, along with that the crankcase seals must be tight, the fuel pump must be working (vacuum operated), etc. 2 stroke-cycle has several different designs used for fuel charge delivery. The most common are roto-port, cylinder port, and check valve. Cylinder port engines (like Stihl) are particularly sensitive to scored cylinders. Your Homelite, as I recall, is a reed valve engine - so the reed valve under the carb. must be working properly.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|