Tractor Talk Discussion Board |
Re: corn burning stoves and wood burning pellet st
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wdTom on November 15, 2004 at 17:48:35 from (155.212.222.193):
In Reply to: corn burning stoves and wood burning pellet stoves posted by Ron Anderson on November 15, 2004 at 11:31:13:
If you want your stove to work better at heating your home try this. Put a register, maybe 2 ft. square, in the floor over it to allow the heat an easy path up. Now enclose the stove in a sheetmetal enclosure to keep the heat in so it will go up. The front of the stove can be even with the front of the enclosure to allow easy loading. Leave a few inches between the enclosure and the floor for air to get in. Leave the door to thebasement open or open a little as a return. Or install a return from another part of the house. This could be another register in the floon. I have seen a system make a huge difference from jsut having a stove in the basement and leaving the door open.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|