Tractor Talk Discussion Board |
Re: OT, putting in a driveway
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on November 16, 2004 at 16:09:43 from (142.177.6.21):
In Reply to: OT, putting in a driveway posted by Joeeey on November 16, 2004 at 10:07:52:
There are likely several different options that will work, with a wide range of costs. In my area, rock is..... quite abundant. I have access to red granite pit run for little more than the cost of trucking, so that's what I have been using. There can be any size in that, up to a foot, and down to sand. If it's too lagre, then I just run the dozer over it. This stuff is soft and packs well. I just dump a load and spread it about 8" - 12" thick, and I have a road. Beyond that, the most important thing to deal with is drainage. If you have cheap material like I do, there is no need to cut the grade, or do any fancy building. A skid steer or front end loader will do the trick. This also depends on what traffic will be running on this. Trucks need better roads. If it's just a car, then you can get away with less. The fabric is also another option. I have never used it myself, but I have seen some jobs that were done with it, and they looked good to me. Driveways are something that can consume endless amounts of money, so decide what you need and what you have, and go from there. One thing I would not use is field stone or round cobbles. They just don't pack unless there is about 2 feet. 1 foot of shale rock is also good if you have access to it. It may not hurt to consult with another contractor too. Good luck. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|