Tractor Talk Discussion Board |
Re: How to check glow plugs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on December 02, 2004 at 09:55:02 from (66.163.134.177):
In Reply to: How to check glow plugs posted by Jaker on December 02, 2004 at 09:22:22:
They will show REALLY LOW resistance with an Ohmmeter, if good. The trouble is, most common meters are not real good at reading low Ohms values accurately. I would think they would read less than a couple of Ohms, or perhaps even less than an Ohm. You could check the value of a new one, or known-good one, and compare that to the others. To check glow plugs, I use an Ammeter capable of reading 60 Amps. Connect the (+) side the ammeter to the (+) battery terminal, and, (after unhooking all the glow plugs from the wiring), momentarily touch the (-) lead from the test Ammeter to each glow plug one at a time, and note the Amp draw of each glow plug. DO NOT power up a glow plug for more than a second or two, as they may be damaged and break, causing engine damage, since you are feeding power direct, and the controller is not in the circuit to protect them. I don't know what the Amperage draw of your specific glow plugs should be. Typically, diesel glow plugs draw from 10 Amps to 30 amps each, depending on the specific application, and, for a specific application, the Amperage draw will be very close between all the cylinders. Since you are having trouble with one cylinder, you can compare the Ohms reading, or the Amperage draw of that glow plug to the others, and any substantial differance will indicate a bad glow plug.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|