Tractor Talk Discussion Board |
Re: shelling trench in a corn crib
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RickL on December 06, 2004 at 06:10:06 from (69.66.78.154):
In Reply to: Re: shelling trench in a corn crib posted by fixerupper on December 05, 2004 at 11:01:01:
fixerupper; The exact lengths of the drags doesn't really matter now as I am not positve either now as it has been to long. I do remember these memeories though. the bet who would get the most rats stuck on the end of your corn rake. Its was sure funny finding out you could dance when one tried to go up your pant leg and some made it!!!. You seen all kings of (fruit of the Looms) somtimes.You learned the cribs to watch out for after that first time shelling in some cribs. Everybody tied there pant legs shut with baling twine or baling wire. We really got fancy when we finally used good old duct tape since we always had rolls of it in the cab of the sheller to patch thin spots in the metal or chuite canvas. The other dare (tough man) or kid who didn't know any better was to have another crew member hold ear of corn between his hands from both ends. The tough guy was to break it in half with a swing using the side of his hand. We had one fellow who could really do it allthe time!!!! I was dared to do it the first rookie season,never again though as my hand hurt for weeks and was black and blue!!!! This was are fun!!!! One fellow did break his hand!!!!. You get some of those dried out ears they are just like steel. To me the mice dancing activity was hilarious some days. Snakes well thats another story.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|