|
Tractor Talk Discussion Board |
Re: Prony/pony brakes
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Evans on December 08, 2004 at 20:28:46 from (67.129.216.216):
In Reply to: Re: Prony/pony brakes posted by JT on December 08, 2004 at 15:00:19:
No,no! Way too small! If my math is correct, the swept volume of our Fan is 24.7 cubic feet. Your proposed dimensions only yield .57 cubic feet or about 2% of our fan's volume. Your M wouldn't even notice this load. I would suggest as a starting point a fan with a major diameter of 48" and 16" paddles. This will yield a swept volume of 14.8 cubic feet. If nothing more than a 50 HP tractor is belted to it, this should work pretty good I would think. You can dink around with pulley sizes to get the M running the fan at its rated pulley RPM whatever that is. Two pulleys are better than one. A very large pulley on the other end would let your small stationaries get a good work out.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
