Tractor Talk Discussion Board |
Re: OT: Tips/ideas for pole barn, do's/dont's.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george md on December 26, 2004 at 18:12:39 from (65.216.222.101):
In Reply to: Re: OT: Tips/ideas for pole barn, do's/dont's. posted by marlowe on December 26, 2004 at 14:35:53:
Markss, I agree with Marlowe, end doors only . Also I didn't see any answer to your question about overhang ,I built one building with 6" on the sides and none on the ends , seems that was the great idea at the time 30plus years ago. I will never do that again , 6 years ago we built the overhang for that building(2 ft) and put it up . Overhang is the best thing you can do for your doors. All the other buildings had at least a foot on the ends and 2 ft on the sides , all block buildings. george
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|