Tractor Talk Discussion Board |
Re: OT: painting my new pipe fence
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin (FL) on January 04, 2005 at 11:58:36 from (12.77.199.242):
In Reply to: OT: painting my new pipe fence posted by Stergil on January 04, 2005 at 11:21:11:
Stergil, In the oil patch, we would use what's generally called "surface tolerant" epoxy. I would at least wire brush the gate portions that are pretty rusty and then wipe with some hot thinner to clean. For the new pipe, if its dry and not covered with dust and dirt, you can apply the epoxy directly. Two coats are better than one but if you have a good sprayer, you can apply a fairly heavy coat and be done. Epoxy is a "hot" paint and is self curing--like fiberglass. Some brands sell two part mix and others sell as one-part already mixed and ready to spray. The paint is very durable and is extremely hard after curing. Enamel is easier to apply and cheaper, but not as durable. Only complaint I have is that the expoxies tend to "chalk" after about 10 years in the sun. Follow all safety warnings and use a good respirator and good ventilation.
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|