|
Tractor Talk Discussion Board |
Re: Ferguson TE20
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Ian on April 28, 1999 at 23:24:38:
In Reply to: Ferguson TE20 posted by Randy L. Claflin on April 17, 1999 at 15:24:09:
Your fergy has a wet sleeve motor , that is the sleeves can be pressed in and pulled out of the block, it is surrounded by water. At the bottom of of the 4 sleeves there is 2 figure 8 gaskets that stop water going into the sump, it is very common ( especially if you have had the head off ) that you lose the
seal of the gasket
You will have to pull the sleeves out and clean it up and install new gaskets , everything has to be in good shape to get a good seal , it all seals as you torque the head down so cleanliness and preperation are vital .
If your sleeves pistons etc are worn you may as well replace the lot as new sleeves with matching pistons and rings are very cheap, its the time to do it I'm in Australia where parts are very cheap for fergys Hope this helps.
Follow Ups:
Post a Followup
|
