Tractor Talk Discussion Board |
Re: Snow blade
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by HoneyRancher on January 28, 2005 at 17:27:43 from (63.190.104.159):
In Reply to: Snow blade posted by Pawel on January 28, 2005 at 10:14:01:
I plow snow with a 30 HP Kubota with a front loader & rear blade. The blade is a 7' LandPride, pretty heavy duty. I put 'er in four wheel drive, put the loader in FLOAT with the bucket curled so it's front edge is about 2" off the gravel, angle the rear blade about 30 degrees and REVERSE it so I am plowing with the backside of the blade (keeps it from digging into the gravel or getting hung up on frozen rocks or lumps). I plow forward in 5th or 6th gear and let the loader bucket fill up so it acts like a straight blade in front. I do not have chains or loaded tires and I have plowed through 12"-16" snow. If you don't get it all on the first pass, go back over it again. If the windrows at the sides get a little high, push them back with the loader after you have cleared the main part of the driveway. If you don't have a loader, you can back into the pile with the back blade and push it but you have to be careful not to break it (as you already know). You can also take a minute to get off and reverse the blade so you can back up and push with the back side of the blade. It might ride up some but it will probably push enough to work and it won't dig into the ground or break on the frozen ground. I also have a hydraulic top link on my 3 point so I can tilt the blade but I don't use it much in plowing snow. Dress warm, relax and enjoy the tractor time! Hope this helps a little.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|