Tractor Talk Discussion Board |
Re: Snow blade
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 30, 2005 at 03:19:14 from (216.208.58.122):
In Reply to: Snow blade posted by Pawel on January 28, 2005 at 10:14:01:
Pawel: To start with I would never buy a loader to plow snow with. Might use one some if I owned it. Just about every tractor loader I've ever seen that plowed much snow has been twisted by the job. If you notice you will see farm tractor loaders that hang low on one side. 9 times out of 10 that has occured hitting something, when plowing snow. If you take the advice of guys that suggested chains, that will be your very best move. You will actually damage your current blade less, because of the increased traction, you will not need to take runs at snow to get through. The slower speeds will actually be easier on the whole unit. The only thing a front blade will actually do for you is save your neck. The biggest trouble I ever get into plowing snow with my Farmall 130, I push too far, snow falls behind my 18" high by 6' wide blade, then I cant back away. Happens quite often without chains, and has happened once this winter with chains on. That will very rarely happen with a rear blade. Now if I were wanting to get into snow plowing business, where you are running from one residential area to another, pickup with angle plow is the way to go. Buy a trailer and a 40-50 hp skid steer to compliment the truck. Those loaders will stand up, the big benefit being you see more of the frozen or concrete obstacials.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|