Tractor Talk Discussion Board |
Re: Diesel engine break in
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mattd on February 11, 2005 at 14:37:49 from (207.91.18.48):
In Reply to: Diesel engine break in posted by Northwest dude on February 10, 2005 at 21:15:42:
i believe the only way to break an engine in is to put jd break in oil in, let it warm up. then find the biggest implement you think it could pull then give her h*ll. ive heard of mechanics taking their freshly rebuilt tractors over to very big trees and set the front end against the tree and let the tires spin. with no probelms. with modern honing patterns the only way to get the rings broken in is to work the engine very very hard from the moment you first turn the key. otherwise the rings wont get broken in, and you'll get blowby early. i found a website that explained this theroy very well, i will try to find it and post the address also do the oil changing intervals others have mentioned matt
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|