Tractor Talk Discussion Board |
Re: Flip over question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave (IL) on February 16, 2005 at 18:13:10 from (24.14.103.132):
In Reply to: Re: Flip over question posted by Hugh MacKay on February 16, 2005 at 16:58:58:
I in now way meant to demean the folks on this board by mentioning a safety expert. I think it's fantastic that people on this board are willing to share their experience and wisdom regarding not only safety, but virtually any issue. It's excellent to provide the examples of "this is a safe way to git'er done" and "this is a dumba$$ way to do that" and the wonderful thing is the broad list of examples this group can come up with. Wouldn't you agree that there is some added value in exploring the mechanics of what will cause a tractor to back flip? Armed with both the examples AND the theory (why it's going to flip) then intelligent people can recognize the root cause of the accident in a situation that may fall outside of the examples that have been presented. A casual reader of this thread (and others even in the puller forum) could come away with "it flipped because they used a small tractor to pull a big stump" and proceed to pull a stuck car out of the mud attached to the top link or the 3 point drawbar with a chain top link. (just happened again) The next casual reader might read "it is impossible to flip a tractor pulling from the original drawbar because it has been engineered to only raise the front end so far and then stop." and be woefully unprepared with clutch and throttle the next time they attempt a difficult pull. Yes, the "expert" I referenced is a college professor who collects a lot of case studies and statistics, etc. , but he also is a recognized expert on the mechanics or dynamics of what conditions actually cause a tractor to flip, and I think that might be worth hearing about.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|