Tractor Talk Discussion Board |
Re: Jon H...Chev 350 oil pres
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon H on February 25, 2005 at 09:51:53 from (69.26.17.242):
In Reply to: Re: Jon H...Chev 350 oil pres posted by Jon H on February 25, 2005 at 09:26:42:
I missed you question about oil pumps in my first post. All automotive oil pumps that I have seen,chevy included have a pressure regulator valve built into the pump. There was also the question about welding the oil pickup tube in a chevy pump. This advice is almost manditory on a race engine where the vibration of 8000 rpm will oftem shake the pickup out of the pump. My caution is to weld then quickly cool the weld so you do not heat/weaken the pressure relief spring and cause a low oil presure problem. One other point that pertains to older engines with the old flat tappet camshafts more than the newer ones with roller cams. The camshaft is almost totally lubricated by oil thrown off the crankshaft and rods. an engine with a "loose" bottom end will do a better job of lubricating the cam than a tight one that opens the pump pressure regulator and dumps excess oil back into the pan. This is important on a high performance cam with stiff valve springs.
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|