Tractor Talk Discussion Board |
needle valve won't quit leaking
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cjm in wi on March 03, 2005 at 10:36:13 from (66.84.140.146):
I have a Zenith carb that was leaking so I bought a rebuild kit and took it apart. It seemed pretty clean inside but I replaced all the parts and cleaned everything up and put it back together. It still leaks. I put it in a glass jar like the picture in stuck and troubled and it leaks past the needle valve. About a drip every 6 seconds. I have adjusted the float six ways from sunday and it won"t stop that last little drip. What is my problem?? What else can I try??It is a new valve and guide. Even tried the old valve as well. I would like to get this perfect if possible. Any ideas appreciated. Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|