Tractor Talk Discussion Board |
Re: Bleeding 3208 injectors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CB 48 on March 07, 2005 at 08:16:24 from (148.78.249.10):
In Reply to: Bleeding 3208 injectors posted by Tom S. in Tn. on March 07, 2005 at 06:18:34:
I have 2 Cat 3208"s and have been required to bleed them a few times. I open the little t shaped valve on top at the front center of the engine then hand pump the primer pump till the fuel flows out at the bottem of the engine then close them and it will start right up. I will be watching this Thread closly to see what others may have to say on this in case I have a problem some day.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|