Tractor Talk Discussion Board |
Re: Is running a dozer hard to learn?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dr.sportster on March 07, 2005 at 10:58:30 from (209.247.222.92):
In Reply to: Is running a dozer hard to learn? posted by Thomas2 on March 07, 2005 at 09:09:54:
My answer from experience, yes, hard as heck.When I was in the Marines I was A metalworker[weldor]I worked at Engineer Test Area.They wanted non-operators to dig tank traps for a Case dozer Vs a John Deere dozer[civilian machines] test.First you cut too deep then too little then too deep then too little and so on.Then at a later date they let my operate a road gradter.Forget it.All the while real operaters yelling advice to no avail.Experience money cant buy holds true on this one.I even had licsences for equipment I could not master.Takes lots of practice.Dont ask about the time we got everthing the place had stuck in a swamp off Rt.1.I didnt even read the other guys answers yet but thats my experience.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|