Tractor Talk Discussion Board |
Re: Banjo hydraulic fittings, used on vintage trac
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Scott on March 16, 2005 at 11:13:37 from (192.65.17.24):
In Reply to: Re: Banjo hydraulic fittings, used on vintage trac posted by Mike Becker on March 16, 2005 at 10:25:29:
Mike from KS, Thanks, but no that won't help. These are for SAE-8 (3/4" x 16tpi) ports. They have to have a 3/4" hole through the banjo head. Square is not a problem, and an O-ring seat would be great. I've even thought about getting a hose fitting and drilling out the hose barb to braze on tubing (some have a large diameter boss at the banjo body that could be drilled out). But regardless, a 5/8" hole isn't going to help. It was suggested to me that older vintage tractors might have used these fittings more, and that seemed like worth a shot, but maybe not... Thanks much!
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|