Tractor Talk Discussion Board |
Re: Hauling a Farmall M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on March 19, 2005 at 22:44:35 from (4.240.132.253):
In Reply to: Hauling a Farmall M posted by Lerm on March 19, 2005 at 17:50:40:
Hi Lerm, A Farmall M weighs about 5500lbs wet according to my book. Be sure and tie it to the trailer with chains in four places. X the chains slightly towards the center of the tractor from the front and back. This way the tractor can't bounce forward or backwards or sideways during transit. Ratchet chain binders work well. Pull for a few miles then pull over and recheck your load. Do a walk around inspection every time you stop before you leave. Keep them chains tight! A Easy way to set your load tonque weight is to set your tongue jack to the ground, then raise it back up 2" off the ground, then load the tractor forward until the jack just touches the ground. This is the added TW of the tractor. Don't forget to raise the tongue jack when done! You can always bolt 6"/10" channel iron across the bed frame, web up, with angle iron kickers and set the tires inside the channel irons for extra bed width. Like a frame on a frame construction. If you can move the tires in, thats alot easier. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|