Tractor Talk Discussion Board |
Re: Pulling force of a tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on April 08, 2005 at 11:21:34 from (66.60.197.142):
In Reply to: Pulling force of a tractor posted by Mike (Burford) on April 08, 2005 at 10:32:53:
No one cares about the operator.... ;) The shear bolt breaks when you hit a rock. Something will break, you really hope it is the shear bolt. Otherwise the frame, bar, tractor 3pt linkage, or a rear end gear _will_ break. The shear pin would be sized to the point in the ground. The implement will be sized to the tractor by the # of points you have. So, look at the commercial ones you see, and measure the size of the pin, the depth of the point from the pivot pin, and the distance from the pivot pin to the shear pin. All 3 of those numbers are important, and if you build exactly the same, you can use the same size (and grade of course) of shear pin. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|