Tractor Talk Discussion Board |
Re: Honda 3813 - valve problem saga continues
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by phil25 on April 15, 2005 at 03:40:38 from (165.154.46.209):
In Reply to: Honda 3813 - valve problem saga continues posted by PaulG1 on April 14, 2005 at 21:53:05:
On the off chance this might help: Have you checked the valve clearances? I had a 13hp that would run great at idle and would speed up smoothly. BUt when load was applied it missed and stalled quickly, because the intake cam lobe was not fully made from the factory. Just enough lift on the intake valve to run the engine,[4thou lift] the valve barely moved when watching it. Installed a new cam and all was great, if you do change the cam, ithe new one had two timing marks on it[one wrong one right]as it fits different engines, just a assembly note, the engine/valves seize when the wrong mark is used. good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|