Tractor Talk Discussion Board |
Re: wide vs. narrow front
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve (Magnolia, TX) on April 27, 2005 at 14:40:44 from (15.235.153.95):
In Reply to: wide vs. narrow front posted by Chad Berberich on April 27, 2005 at 14:23:58:
1. Stability. For those days yer whippin' around at 90 mph and hang a hard left turn... you're less liable to roll 'er over with a wide front-end 2. Tractor height. I'll most likely prove my ignorance with this one, but... ALL (OK, most?) narrow front-end tractors will be row crop tractors, which have a higher clearance, therefore are further from the ground. Whereas SOME wide front-end tractors are "utility" tractors and don't have the clearance requirements of a row-crop and therefore are closer to the ground 3. Turning radius. In most instances (dare I say all instances?) you can make a MUCH sharper turn with a narrow front-end tractor than you can with a wide front-end... of course, therein lies a greater chance of you digging ruts with the front tires, too... 4. (and in my opinion the biggest factor) Personal preference. Some folks just like a narrow front-end tractor. Now take me, for instance. I grew up on IH/Farmall tractors, most of 'em were narrow front-end. And if you ask me, that's pretty much what a tractor should look like. However, I'm not doing any row cropping and just can't justify 2 tractors, so I'll just keep the Ford 8N that I bought about 8 years ago. I like it (a lot) and it's served me well, but it's a smaller tractor, with a wide front-end, and I suppose it looks a little "less-like-a-tractor" than what I grew up with... HTH Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|