Tractor Talk Discussion Board |
Re: complete tractor ignorance HELP
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big jt on May 22, 2005 at 23:18:46 from (206.72.54.246):
In Reply to: complete tractor ignorance HELP posted by bigjay on May 22, 2005 at 22:22:05:
Forgot to mention. You could be getting low voltage to the coil. Caused either by the lack of a charging system or a bad or to large resister in the coil primary circuit. Most times on 12v conversions I don't use a resistors. Have found they cause more problems than they solve. Matter of fact I just mowed my lawn with a AC WD45 this afternoon, this tractor has a 12v conversion on it without a resistor and has been running on the same points, condenser and coil all from the 6v system for 15 years. jt
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|