|
Tractor Talk Discussion Board |
Re: Grain Drill
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Indydirtfarmer on May 25, 2005 at 08:02:03 from (66.64.181.106):
In Reply to: Re: Grain Drill posted by Allan in NE on May 25, 2005 at 06:28:04:
Allan, You MUST have a bucket-o-cash just to afford all that shiney red paint you've been buyin'.... Those 750 drills sell for MEGA-dollar... I've seen a couple "wrecks" sell for $7500, but expect $10,000 for a good condition model. (and maybe MORE) The "artificial inflated value" is because they're the #1 no-till soybean drill as we speak. You'd be better off (since you're wanting to save a few pennies) to look for something "pre-90's" before the solid-stand no-till soybean craze hit. The Deere 8300 is a good alternative, as is the IH model (# escapes me at this moment) built in the late 70's early 80's. The old Deere FB-B is a good piece if you can find one not ravaged by time...
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
