Tractor Talk Discussion Board |
Re: e-85 fuel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gerald J. on May 29, 2005 at 21:04:15 from (67.0.109.100):
In Reply to: e-85 fuel posted by n8terry on May 29, 2005 at 20:55:32:
I don't see that 10% loss using e-10. My truck runs smoother on E-10. I use E-10 most all the time in Iowa. Its cheaper than straight gasoline. The computer controls the injectors just fine. Unless your vehicle is a Flex Fuel Vehicle, you don't burn e-85 in it without the chances of doing damage. It does take more and the injectors can't supply enough at full throttle. Leaning the mixture can burn pistons. Then E-85 can be harder on gaskets in the fuel system. 5 years ago UTex converted a Chevy truck and the main change was larger volume injectors. They also changed some of the gaskets and moved the fuel pump out of the gas tank and added a better flame arrestor for the filler opening believeing that the atmosphere above the fuel with e-85 was more combustible than that above gasoline. EPA and CARB don't want vehicles to be converted to run on E-85 because they think the emissions will be made worse but they like factory option e-85 vehicles. More than ecomonics is the principle of not burning imported gasoline. Burning e-85 (or e-10) is good for us corn farmers. Gerald J.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|