Tractor Talk Discussion Board |
Re: 640 hydraulics
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john in la on June 11, 2005 at 20:14:15 from (65.6.119.60):
In Reply to: 640 hydraulics posted by straberiwine on June 11, 2005 at 18:29:32:
That depends on what you mean by "is this something for me to worry about" If you mean should I get rid of this tractor and get something that parts are available for or loose sleep over; I would say NO. If you mean should I take care to do every thing I can to prevent having these lines go bad in the first place; I would say YES. These hyd lines are in the bottom of the trans compartment and it is true they are no longer available. I think they are even getting hard to find used. The length of the tube is the same ID but the OD is in 3 steps making ordinary tubing hard to use. Some have had them turned on a lathe and others have put Millimeter size tubing in the old tubing to make them work. Your best bet is to do what ever you can do to keep your tubes usable. These tubes meet their demise because of rust. Since they sit in oil and have oil running through them rust should not be a problem if every thing works correctly. BUT when your shifter boot gets worn and you let it go; it lets water into the trans. If you do not replace the oil regularly these tubes are then sitting in water so they rust out creating a leak. Change your trans and hyd oil regularly and repair any spots where water can get in. Condensation will still happen but if you use your tractor regularly it should boil off this small amount of water. But if you use your tractor once every 4 months; park it outside in the rain; do only what you have to do to keep it running in the maintenance department; then get ready to replace these tubes.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|