|
Tractor Talk Discussion Board |
Optical Tachometer:Different Pulley Diameters-QUES
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andrew H on June 18, 2005 at 16:57:12 from (66.131.254.174):
I have a Ford 550 TLB. Proofmeter cable is busted so I can't get a reading on my RPM's. I bought a Laser Optical tachometer on eBay to get a reading on the RPM's. Now here's my question. There are 3 pulleys all connected by one belt. I assume that the true correct reading would be off the main pulley that comes off the motor drive shaft, but I can't access it with the laser. The only pulleys I can access are the water pump pulley and the alternator pulley. Now, the diameters of the water pump pulley and the alternator pulley are much smaller than the main drive pulley. So if I take a reading off them, I am not getting the true engine RPM right?
The water pump pulley is only about 20% smaller than the main drive pulley.
Question- IfI get an idle speed reading of 580 RPM at the water pump pulley, what would be a ballpark figure for the engine RPM?
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
