Tractor Talk Discussion Board |
Re: 3010 leaky pto shaft(s), remotes,etc
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by msb on June 21, 2005 at 20:45:39 from (12.208.37.116):
In Reply to: 3010 leaky pto shaft(s), remotes,etc posted by Mark ss on June 21, 2005 at 09:56:57:
Patience my friend ,Patience.We can walk myou right through those seal replacements Its no big deal so long as the load control shaft isn't leaking.That is the shaft that goes through the wishbone casting the drawbar is attached to.A special driver is needed to install those two seals, however.The others you mentioned,ordinary tools are all you will need.You took a giant step going from a 2010 to a 3010.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|