Re: NH baler won't run

Posted by Bernie in MA on June 23, 2005 at 17:36:33 from (66.19.204.174):

In Reply to: Re: NH baler won't run posted by chris sweetland on June 23, 2005 at 16:09:06:

If there is little or no compression the valves are probally stuck. Squirt some penetrating oil in the plug holes, let it set a while, then try tapping the valve(s) down by putting a medium sized allen wrench in the plug hole and rotating it to contact the top of the valve. Tap the end of the wrench and if you're lucky you'll hear the valve snap down. Turn the engine over. It will likely stick again so repeat the process. Good luck.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]