Tractor Talk Discussion Board |
Re: irragation
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matt from CT on June 28, 2005 at 10:44:48 from (66.181.93.142):
In Reply to: irragation posted by chris sweetland on June 27, 2005 at 16:34:49:
Had a pump for my garden. Quickly learned it used a heck of a lot of fuel for not much really effective water. Right now I use several standard lawn sprinklers off the well & electric pump for the house (big well, I don't have to worry 'bout that!) I'm now starting to put in soaker hose. Next step (next year maybe) will be to rig up a couple barrels. Fill the barrels from the well and/or use the pump again. Let them slowly drain out via the soaker hoses. Some of the soaker hoses have minimum PSI to work with, so I'll have to be careful to make sure the barrels are located high enough, but it's not onerous. 2 acres is a lot...but Gasoline = $2.25/gallon 5/8" Hose @ Ocean State Job Lot = $15/50'. (Factory blemishes, etc...) Couple garbage cans, fittings, etc...$40. Tiny Drill bit and my time = minimal money 200' of garden rows irrigated with a home-made drip hose would take about $100 and half a day I reckon. Could even time how long it takes the barrels to empty and put the garden hose from the house on a cycle of like on 5 minutes every hour to refill them. And I know I'll deliver a lot more usable water than I ever did with a $300 pump sucking a gallon an hour of fuel...and needing three or four hours at a shot to really give the garden a good drink. Granted 2 acres is a lot more area and thus time and hose, and the soaker hoses aren't ideal for everything...
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|