Tractor Talk Discussion Board |
Re: Dismounting old tractor tires
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Burnie on July 21, 2005 at 03:12:26 from (144.138.74.78):
In Reply to: Dismounting old tractor tires posted by Mike from cny on July 20, 2005 at 21:48:41:
Firstly, I"m with Jerry, get someone else to do it. But if you must have all the fun for yourself here are a few pointers. It will be eaiser to leave the rim on the tractor but make sure any water is removed and there is no way it can fall off the jack [safty stands are highly recommended]. The sliding hammer type bead breaker is pretty useless in this situation, you are better off using an air operated one or the type you hammer in then turn a nut to spread the fingers. I have sometimes had to cut tyres off rims with a 9 inch angle grinder and metal cutting disk but you have to be very carefull of kickback and rim damage. When levering the tyre off the rim, start at the top and work your way around. Same with putting on the new ones: rest the top of the bead on the rim, push on the tyre and hit it on bit by bit with a big hammer. It would be good if you had someone to help you; I"d do it but you would have to pay my airfare. Good luck with it Mike. Burnie.
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|