Tractor Talk Discussion Board |
Re: Hay problem, need advice(kinda long post)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BobMo on July 25, 2005 at 07:40:53 from (66.100.114.28):
In Reply to: Re: Hay problem, need advice(kinda long post) posted by Brokenwrench on July 25, 2005 at 06:40:14:
Maybe he just opened a bale where you had a damp slug. I'd sure go bust a couple and take a look. Also take you moisture and temperature probe and get some readings. Hay should heat up some in the bale to cure right but not to the point of molding. Normally as you know you can generally feel this heat when your taking it off the wagon. Bales that wick up moisture from the ground will mold differently than if baled with to much moisture plus its a different type mold. High moisture when baled will mold from the center out. Apparently your experience didn't set off any alarms so I'd sure question it. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor: Part 2 - by Anthony West. In February 1953 production of the ETC T.V.O engine started, ready for the March 1953 press announcements. The new TVO engine had a number of improvements which resulted in a 10 per cent more power (43bhp as against 38 bhp on the earlier engine) and 10 per cent more fuel economy. Some of the improvements are listed below: Redesigned combustion chamber, improved spark plugs and positioning, plug size 14mm(earlier size 18mm).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|