Tractor Talk Discussion Board |
Re: 220 wire size Hello buickanddeere and T-Bone
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 29, 2005 at 09:24:54 from (216.183.130.177):
In Reply to: Re: 220 wire size Hello buickanddeere and T-Bone posted by john in la on July 29, 2005 at 04:12:35:
Ok you are providing some info previously missing about the large and small bank of heaters. At 1st it appeared the heater was "one unit". The fan will run at about 7.8 amp. As 15amp breakers are the smallest common off the shelf breakers. Anything with running currents of less than 12.0amp are considered "protected" by the 15amp breaker. The fan supply could be tied in at the bottom of the 30 amp heater breaker but that's stretching the 30 amp breaker’s 80% loading rule. You have to have a local disconnecting means right at the compressor unit. It would have been cheaper and safer to run a single set of 80 amp breakers in the home service panel. And a single set of #4 copper to the top of the 60 & 30 amp heater breakers. Two sets paired breakers and four live conductors instead of two running over to the AC equipment. Would have been looked upon better by inspectors as well. They prefer to avoid multiple sources of power into a piece of equipment if possible. Where is the 40amp short circuit protection breaker, overload thermals and contactor for the AC compressor? Inside or outside? Where is the top of that 40amp breaker tied to? I wish I could see the whole setup in person and get an overall grasp of what the manufacture sent you. And I don’t intend to insult by saying what you have worked on and planned your best with, isn’t satisfactory.
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|