Tractor Talk Discussion Board |
Heres how I do it (long Post)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred Martin on August 04, 2005 at 12:02:05 from (69.218.163.49):
In Reply to: Bush Hogging posted by Ken-in-K on August 04, 2005 at 08:08:06:
You don"t need to worry about blade suck on a bush-hog...all you need to worry about is getting rid of the stuff that is cut...getting it out from under the deck. Some mowers have what is called a hay side...you unbolt one side and take it completely off and the mower will put the cut out that side...kinda in a windrow. That shoots the suck idea. If you ever mowed acres and acres as efficiently and fast as you can (mowing by the acre) you will probably wind up with the back a little higher than the front...it helps a small HP tractor to keep from pulling the engine down as much. Hanging the front of the mower on chains and the back a bit higher is as good as it gets...then if it starts to pull the engine down your only alternative is to pull out of the cut and don"t take as wide a swath. I always use the term "it turns to wood come August" and it"s tougher to cut. It also has plenty of seeds and chaff to clog up your radiator so check it and clean it off once or twice an hour. I think if you don"t have experience and follow these guidelines and keep the blades sharp and if you haven"t mowed that acreage before...keep the blades about 5 or 6" off the ground the first time, you"ll get by okay. I generally keep an eye out ahead and also look over the next swath to be cut all I can. Hard to see everything. And if you bought a used mower, check the lube in the mower gearbox till you see if it leaks any out. And when mowing those 6" high weeds, be careful...I"ve just barely got stopped when a big ditch appeared out of nowhere. I don"t know it all, I learned something new everyday or tried to...you do the same. Fred OH
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|