Tractor Talk Discussion Board |
Re: Assessing an unknown engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Redmud on August 07, 2005 at 16:09:15 from (216.167.146.154):
In Reply to: Assessing an unknown engine posted by L.C.Grey on August 07, 2005 at 09:53:37:
Remove the head and run a hone in the cylinders above the pistons, vacuum out the rust and crud and add ATF and Kerosene or Diesel to all cylinders. Remove the oil pan and then let the engine set for 24-48 hours. The cylinders that have drained of the fluid that was added to them are ready for piston removal. The ones that didn't drain, are the ones that were stuck in the first place. You may only have one or two pistons that are really stuck, but removing the ones that are not, first, makes the stuck ones just a tad more easy to remove. And for those you use the jack on the crank trick.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|