Tractor Talk Discussion Board |
Re: O.T. 2000 Powerstroke Crankshaft Positioning S
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RusselAZ on August 13, 2005 at 21:55:19 from (67.136.84.192):
In Reply to: O.T. 2000 Powerstroke Crankshaft Positioning Senso posted by Gus on August 13, 2005 at 16:31:35:
You all have the general idea. The cam sensor on a 7.3 power stroke is the only sensor that tells the injector controller where cylinder #1 and cylinder #4 is in the rotation. Any missing or garbled signal that the ECM can't recognize will instantly shut off the engine. And I mean Right Now! IT also sets a code which tells a technician esentially to change the sensor. If you didn't have the codes cleared you need to have it done as the code will stay in the ECM forever. Clearing has to be done with a scan tool. Any one that owns a powerstroke needs to carry a spare cam sensor and know how to change it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|