Tractor Talk Discussion Board |
Re: pay check of a welder...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by upred on August 14, 2005 at 19:17:21 from (24.231.136.16):
In Reply to: pay check of a welder... posted by Tim Shultz on August 14, 2005 at 18:20:23:
get certified, just because you can weld or lay abead down isn't being a welder. What type of welding can you do? overhead, vertical up, vertical down, wire feed, core wire, mig, tig, dc stick is different than ac stick, what type of rod or wire is correct for proper penetration. Dad worked as a welding forman for years and was always getting guys in that could "weld". But the majority couldn't pass the basic test, like setting up the machine properly. I'm not trying to be critical, but just want to point out somethings that employers might be looking for. Get certified is the best advise, that way you will understand the theory as well as the practical parts of welding, and some print reading experience.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|