Tractor Talk Discussion Board |
Re: Off topic Pig Roast
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill in TN on August 16, 2005 at 18:14:14 from (69.246.140.27):
In Reply to: Re: Off topic Pig Roast posted by Scotmac on August 16, 2005 at 17:43:06:
That's a fairly large pig, and will require a couple of men to handle it, especially when it's hot. I've done many, but always over a hickory fire. We wrap the pig in chicken wire and loop it on each end so you can get a metal bar through the loops on each end in order to turn the pig. While I like to do a smaller pig, as it's easier to handle, we don't cook ours near as hot as 400 degrees, but keep the heat low. We start late in the day, just before dark, and start a fire out of hickory. We place the pig on an old army cot, and put a tarp about 3 feet over it, and make something like a lean-to. When the hickory burns down to coals we shovel it under the cot until there is a bed of coal about 2 inches deep. Add coals every 30 to 45 minutes, and turn every 2 hours. Keep the fire burning and plenty of bud on hand. We cook it all night and most of the morning and check the temp. to make sure the pig has reached 190 before serving. Cook pork slow, on low heat or it'll dry out and turn hard. The biggest thing, is to get the hair off and the pig cleaned properly. Again, that's a job that you will need help with. Scald the pig in hot water. If you can't keep your hand in the water until the count of 9 the water is to hot. Over nine and it's to cold. That's the unscientific way, not sure of the exact temp, but if you get the water right, the hair will just wipe off with out much trouble. Your making me hungry just thinking about it. Have fun!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|