|
Tractor Talk Discussion Board |
Re: OT.. souping up a truck
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on August 22, 2005 at 16:25:38 from (216.183.130.41):
In Reply to: Re: OT.. souping up a truck posted by Tim Shultz on August 22, 2005 at 15:35:29:
Good idea. Only problem is it won't work.
Getting extra fuel into an engine is easy. Making that engine pump more air to burn the extra fuel is the trick.
60HP??? I assume your buddy has the printout from the dynometer to prove this? If the gasoline metering system was terribly out of whack but the LP system calibrated bang on. Or maybe the engine has such high compression it knocked on gasoline but ran fine on LP. Then sure 60 even 100+ HP is possible.
You likely didn't notice the engine was a turbo diesel. Or a gasser with NO2 injection along with the LP injection.
Say, you are not mixing up NO2 injection with LP injection are you?
A while back we had a genius figure out he could couple the shafts of a generator and motor together. Then feed the motor from the generator. And use the surplus power to run his house. He was all set to patient the idea to power companies.
There seem to be a lot of people around who didn’t take basic science and physics in high school.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
