Tractor Talk Discussion Board |
Re: 3020 JD gas standard Delco gaps
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on August 23, 2005 at 10:15:22 from (216.183.136.2):
In Reply to: Re: 3020 JD gas posted by buickanddeere on August 23, 2005 at 08:14:01:
Single point Delco Distributors run a 22 thou point gap. It's a conventional Kettering ignition system. A low rpm four cylinder will run fine with a 30 to 35 thou plug gap with a ordinary coil. Depending on the age of the tractor it will be a postive ground with a generator. The coil's + goes to the dist. If it's a later alternator equiped JD the ground will be neg. The coil's - connects to the dist. Depending on which JD and it's spark plug threads. An Autolite 216 or 3116 are less inclinded to foul. And they are both non resisitor. Odds are the carbon resitor wires are failing with too high of resistance or internal gaps. Replace with solid core wires. Points and plugs maynot be enough. Those tractors equiped with Zenith carbs perform better and smoother on less fuel. A compression check and valve lash adjustment is likely over due. A flat feeler gauge won't work if the valve and rocker tips are worn. The clearances will be wider than intended after adjustment.
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|