Tractor Talk Discussion Board |
Re: PTO types
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on August 23, 2005 at 19:25:29 from (142.177.6.5):
In Reply to: PTO types posted by Jim in NH on August 23, 2005 at 17:01:34:
Non live or transmission PTO is just that... the PTO is driven off the transmission. Live PTO uses a 2 stage clutch, and is free of the transmission. However, it's not free of the clutch. The first stage stops the tractor, second stage stops the PTO. Live PTO can not be shifted on the go. Tractor will be stopped, or at least not under power. Independant PTO is just that. Completly, fully indepandant and separate from the transmission and clutch. Most systems use a drive hub on the rear side of the pressure plate which drives a shaft completly through the transmission, and has a clutch behind the transmission to control the PTO. This system can be shifted any time on the fly. Ford, and most others used a hydraulically actuated, multiplate wet clutch to drive the PTO. It works on much the same principle as the clutches in your car's automatic transmission. Some, like Fiat used a dry plate clutch for the indepandant PTO, but most Ind. PTO's were wet. Wet clutches are generally considered to be more durable and longer lasting, combined with being more compact relative to their power transfer ability. Dry clutches are cheaper to make and repair, but generally won't have the service life. The bottom line is that if it requires using the clutch, it's not indepandant. Indepandant is, by far, the most desirable PTO to have. Followed by LIVE. I just wouldn't have a non live PTO on a tractor. Confused or what? Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|