Tractor Talk Discussion Board |
Re: OT: The question of fencing once again!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry/MT on September 05, 2005 at 12:37:49 from (206.183.121.88):
In Reply to: OT: The question of fencing once again! posted by Rauville on September 04, 2005 at 11:27:41:
Several years ago we bought our place in Montana and the survey, conducted before final closing by the Sellers, indicated that there was not a piece of boundary fence on any property line.(Some lines were 15-25 feet in error) In addition, the fence was in poor shape with less than 1/3 of the posts holding the wire up. I contacted the surrounding neighbors, told them what the problem was and told them that I intended to have the fence on the property lines, "as surveyed" since that's what we bought to, and if they had any complaints, to please make them known before we closed on the place.All of them were extremely cooperative and most stated they would help build half of the fence when we wanted to replace the existing line. I'm presuming that there is no dispute regarding the property line and so I would strongly advise you to have a face to face discussion with the new neighbor and explain your position on the need for a new fence. Listen to his reason for wanting a 5 wire fence. (Perhaps you could spit the cost of a extra wire to make a 5 wire fence out of the existing fence if the reasoning is good or just for good will.) By all means try not to make this a legal fight if at all possible. It'll just poison your relationship with your neighbor, cause you a lot of grief and money and it may not be resolved in your favor. just my opinion.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|