Tractor Talk Discussion Board |
I think I messed up
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry L /AZ on September 08, 2005 at 09:48:33 from (216.67.196.215):
I have 13.6 X 28 tires on my ford 850. Have been restoring it and have the tires/wheels off. There are industrial type wheel weights on the inside of the wheels 2 piece type weighing 223lbs. each. I bought new wheels did the reserch and a 13.6 tire should take a 12" wheel ok found two 12x28 wheels realy good price. got them home and guess what! the old wheels are 10x28. I found that the wheel weights are short or the wheel is too deep. How bad have messed up. the weights sit on the inside of the rim and with the wheel center in place there is 1 3/4" gap between the wheel lug and the wheel center. Can I make some spacers to go between the the two ? will that weaken the wheel? Thanks for your advice Jer Ok Allen heres your chance to get even !!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|