Tractor Talk Discussion Board |
Re: gas tank welding- fill with water?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin bismark on September 22, 2005 at 17:19:48 from (64.12.117.7):
In Reply to: gas tank welding- fill with water? posted by LK on September 22, 2005 at 12:38:38:
I would never strike an arc on a tank unless it was full of water, don't think I would trust the air line deal, saw a guy welding on a diesel fuel tank for a case tractor that way once, and only once, don't think he ever worked again after that, then the guy east of my folks place was welding a nipple into a propane tank, never knew how he tried it, I herd the explosion from about 3 miles away, wasn't much left of the garage, he was on what was left of the garage floor, roof, in the trees, his wife was running around out of her head and the dogs had pieces of him, that must have been 20 years ago, people just have no idea how much energy these tanks have in them when they go, the propane tank will kill you, the gas tank might only loose your arms hands and sight. It's pretty hard for something to explode if it's full of water, just use your head and be careful, you probably have just enough time to know you made a mistake and it's lights out with some of these.. Kevin
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|