Tractor Talk Discussion Board |
Re: Marvell-Shebler TSX type B carb
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on September 23, 2005 at 22:22:30 from (64.21.249.40):
In Reply to: Marvell-Shebler TSX type B carb posted by Don E. Foster on September 23, 2005 at 18:51:33:
While having the float level set to spec is a good idea, it's not as critical (within a 16TH of an inch or so) as some people think! Being off a little WILL NOT cause the carb to run over. Start by verifying that the inlet valve seat is tightened TIGHT into the upper carburetor body, and a GOOD gasket is in place so no gas can get into the carburetor by leaking around the inlet valve seat's threads. The fact you have trouble getting gas into the carburetor at times sounds like the float, or even the inlet needle itself, is jamming or binding. Examine the inlet valve needle for any "burrs" or roughness that could cause it to jamb in the bore of the seat, and not close tightly. Verify the float is not leaky and "gas logged". Then, set the float level to spec. Eyeball that the float pontoons are not bent, and that they are centered in the float bowl. Look for any evidence of contact between the float and the float bowl... if the tractor has been run a while, vibration will cause shiney wear spots any place on the float where it touches the float bowl. Bend the float, as needed, to eliminate any contact or binding. Many of us tractor nuts agree, though, it is always a good idea to shut off the gas when the tractor is parked for the day. Even a carb in the best of shape may, out of the blue, "run over", if a flake of crud gets in the needle and seat area.
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|