Tractor Talk Discussion Board |
Re: Concrete wheel weight idea.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on September 26, 2005 at 14:42:04 from (66.60.197.78):
In Reply to: Concrete wheel weight idea. posted by 300Randy on September 26, 2005 at 13:54:52:
Dad made 5 or so for various tractors around here. He used steel wheels. Find one that just sits inside the clamp that clamps on the tractor rim, supports the weight. Did that for the H, which is the same as a 300 row crop. Is the 300U the little feller? Anyhow, probably don't have many steel wheels sitting around any more, but get some mild steel flat about 3/16 and bend into a proper circle of the right size, 4-5" wide. Put on flat surface, sheet of plastic under, a pipe bigger than the axle in the exact middle, few rebars welded in between, fill level with concrete, make 4 holes that line up with the wheel rims, let dry a week. Will be great wheel weights. These dad made are 40+ years old. I surely would _not_ permenantly cast concrete onto the wheel - if that is what you are suggesting. Ick. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|