Tractor Talk Discussion Board |
Re: Leyland 270 tractor Workshop Manual. Fuel inje
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RodinNS on September 26, 2005 at 20:01:56 from (142.177.81.161):
In Reply to: Leyland 270 tractor Workshop Manual. Fuel injector posted by Ady on September 26, 2005 at 08:54:16:
I'm not familiar with Leyland's, but I would expect that the pump drive gear is holding the pump in place, if you haven't removed it. At this point I'm not quite sure why you're removing the pump in the first place. I would start by ensuring that there is a good flow of fuel going to the injection pump. There could be a bad transfer pump. The next step is to try bleeding the system. Provided there is flow to the pump, it should bleed fairly quickly. If it doesn't, then make certain that that fuel shutoff isn't stuck partially back, or otherwise in an off position. If that doesn't help, then remove the side plate of the pump that has "minimec" written on it, and move the throttle ahead and back. Observe the movement of the fuel rack in the pump. It should move. If it doesn't, then it's possibly stuck. Those would be the first things I would look for. Although it is possible that dirt could ingress into the fuel system, I would think the chances of it getting to the pump are slim, provided the fuel filter was kept in good condition. That, and the Minimec/Simms pumps were fairly durable. Removing the pump would be a last resort, after I was fairly certain that it was the source of the problem. HTH. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|